Ameba DigiCap II series Manuale Utente Scaricare il pdf (Pagina 82)

7-15. Setting Up a Software Motion Detection Area

Click , select “Motion setting” tab, as shown on Fig 7-15.1. Just enable “software detection” if

you want to detect whole area, otherwise clicks

to setup area for set up motion detection area.

Fig 7-15.1 Fig 7-15.2

1. On the screen (Shown as Fig 7-15.2), click and drag down to the right with the left mouse key to

form a highlighted box.

2. Click the “Add area” button to add highlighted area. The area will change to a yellow mesh to

mark a protected detection area.

3. If more than one area is desired, repeat 1 and 2.

4. Click the “OK” button to close the window and save your settings.

If no area is selected for detection then full area will be the default.

Removal of a detection area

1. Select the detection area you wish to remove and then click right button of mouse.

2. Click “Delete area” icon and the yellow mesh will disappear and then click “OK” to finish.

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 117 118

Nessun commento

Ameba DigiCap II series Manuale Utente Pagina 82